Failure Correction Chart - Whirlpool WBM35LW Service Manual

10 – FAILURE CORRECTION CHART:
ALLEGED FAULT
Does not Work
Does Not Refrigerate /
Refrigerates not much in
the Refrigerator.
Does not Chill / Chills not
much in the Freezer
Freezing in the
Refrigerator Compartment.
Internal Refrigerator
Exudation.
MSEX0025_rev01
CHECK
If the Power Cable is connected.
If the jack is powered.
If the Potency Module or the
Interface Board is defective.
If the circuit breaker is tripped or if
the home fuse is blown.
Voltage too low. (This may be
noticed through the lamp lighting
oscillation)
Power Cable damaged.
If installation is correct (heat
sources, sunshine, embedding, etc.)
If the Damper Button is on the proper
position.
If there are any utensils blocking the
cold air outlet.
If there were excess door openings
or open doors.
If the evaporator is blocked by ice.
If utensils are placed directly on the
cold air outlet.
If the Damper Button is properly
positioned.
If the Doors are closing properly.
If the Damper Button is on the proper
position.
If still hot, unpacked or uncovered
food was stored.
SOLUTION
Connect it
If not, advise the consumer to
call an electrician.
Replace it.
Reset the circuit breaker or
advise the consumer to call an
electrician.
Advise the consumer to install
an automatic 1000-Watt
stabilizer.
Replace it.
Advise the consumer on the
proper installation and minimum
distance for embedding (10 cm
on the top and rear and 3 cm on
the sides).
Advise the consumer. On days
too hot or with the Refrigerator
too full, the Damper Button
should be set to maximum.
Unblock and advise the
consumer.
Advise the consumer.
There were problems in the
defrosting. Check if the Bimetal
shows any problems, if it is
inproperly positioned or leaned
against the Defrost Heater.
Check if the Defrost Heater is
blown. Check if the Chute or
Defrosting Drain is blocked.
Reposition them and advise the
consumer.
Advise the consumer: on days
too cold or with few food in the
Refrigerator, the Damper Button
should be set to the minimum.
Level the product, check the
gasket and check the Hinge
adjustment.
Place the Button on the proper
position and advise the
consumer.
Advise the consumer.
33