Configuring Vcop Smart Sfp - Cisco NCS 4200 Series Configuration Manuals

Configuring VCoP Smart SFP

Before You Begin
Ensure MPLS and IGP are active between the PE nodes.
VCoP smart SFP supports the following valid CEP Pseudo Wire (PW) configurations:
Note
Mode
OC-3
OC-12
T3
You can configure VCoP smart SFP on OC-3 or OC-12 mode.
1 Enable VCoP smart SFP using the platform command.
2 Configure controller for CEM circuits.
3 Configure xConnect for CEM circuit.
You can configure VCoP smart SFP on T3 mode.
1 Enable VCoP smart SFP using the platform command.
2 Configure controller for CEM circuits.
3 Configure cablelength.
4 Configure xConnect for CEM circuit.
Configuring VCoP Smart SFP on OC-3
Enabling VCoP Smart SFP on OC-3
You can enable VCoP smart SFP for STS1 and STS-3c channels on OC-3.
enable
configure terminal
platform smart-sfp interface GigabitEthernet 0/0/8 type OC-3
exit
Configuring Framing for CEM Circuits for STS-1 on OC-3
enable
configure terminal
controller SONET 0/0/8
framing sonet
sts-1 1
CEP PWs
3* STS-1 or 1* STS-3c
Valid mix of STS-1, STS-3c or STS-12c
1*STS-1
5