Advertisement
10. Slide LED display out of focusing screen slot at wind-lever side
11. Lift out complete flex circuit (Underside of flex circuit may be
glued to top of pentaprism)
12. Unsolder 5 leads form front-plate circuit board
13. Unsolder green wire and blue wire from power winder terminals
14. Rewind-side leatherette; peel back wind-side leatherette far
enough to reach front plate screws
15. Cock shutter
16. Screw at top rear of mirror cage, wind-lever side
17. 4 front-plate screws
18. Front-plate/mirror-box assembly
19. Winding-seat assembly (3 screws)
20. Shutter assembly (3 screws)
REASSEMBLY HIGHLIGHTS:
1.
Replace the mirror-box with the mirror in the released position
and the shutter in the cocked position
2.
To replace the top cover, set the speed selector to the Bulb
("B") position and the wind-lever shaft to the closed position.
Then seat the top cover and turn the speed selector to the auto
setting.
23900
Page 11 of 15
Advertisement
