Table of Contents
Advertisement
List of Error Codes
When turning on the computer, if one of the following error codes or messages is displayed, follow the instructions shown below.
If the problem persists, or if the error code or message displayed is not shown here, contact Panasonic Technical Support.
Error Code/Message
Invalid system disk.
Replace the disk, and then press
any key
0200: Failure Fixed Disk
0211: Keyboard error
0251: System CMOS checksum
bad - Default configuration
used
0271: Check date and time set-
tings
0280: Previous boot incomplete
- Default configuration used
0613: Serial Port*
1
configura-
tion changed
1
0614: Serial Port*
config. error
- device disabled
*
1
The port name, such as A or B,
is displayed, indicating the con-
flicting ports.
Press <F1> to resume, <F2> to
Setup
Operating System not found
How to run the Setup Utility
1
Turn on or restart the computer.
2
Press F2 while [Panasonic] boot screen is displayed soon after the computer begins the startup procedure.
If a floppy disk is set inside the floppy disk drive when it is connected to the USB port,
remove the disk and press any key.
Disconnect any device connected to the USB port other than the floppy disk drive.
Disconnect the hard disk drive and reconnect it again. Make sure the drive is secured
correctly.
If an external keyboard or mouse is connected, disconnect these devices.
An error has occurred in the memory that stores the Setup Utility settings. This error occurs
when the memory content is changed through some inadvertent operation by a program or
other function.
Run the Setup Utility and load the default values, then change the settings to the appro-
priate values as needed.
If the problem persists, the internal clock battery may need to be replaced. Contact Pana-
sonic Technical Support.
The data and time setting are incorrect.
Run the Setup Utility and set the date and time correctly.
If the problem persists, the internal clock battery may need to be replaced. Contact Pana-
sonic Technical Support.
Startup has failed repeatedly, so the Setup Utility settings have been returned to their default
values, and the computer has been restarted.
Run the Setup Utility and load the default values, then change the settings to the appropri-
ate values as needed.
I/O address and IRQ settings are in conflict.
Run the Setup Utility and change the settings in [Advanced] menu so there are no port
conflicts.
Write down the error details and press
settings, and change the settings to the appropriate values as needed.
The OS is not properly installed on the floppy disk or the hard disk that you are trying to
boot from.
If the computer cannot be booted from the floppy disk drive connected to the USB port,
make sure there are no non-bootable floppy disks in the floppy disk drive, then run the
Setup Utility and set [Legacy USB Support] in [Security] menu to [Enable].
If the computer cannot be booted from the hard disk, confirm whether the hard disk is prop-
erly recognized in [Information] menu of the Setup Utility.
If the hard disk is recognized, perform the reinstallation procedure. If not, contact Pana-
sonic Technical Support.
Action
F2
to run the Setup Utility. Confirm the
23
Advertisement
Table of Contents
