Advertisement
P P P P o o o o w w w w e e e e r r r r
BATTERIES
Your TV requires four AA batteries (not
supplied). For the best performance and
longest life, we recommend RadioShack
alkaline batteries.
Cautions:
• Use only fresh batteries of the required
size and recommended type.
• Do not mix old and new batteries,
different types of batteries (standard,
alkaline, or rechargeable), or
rechargeable batteries of different
capacities.
Follow these steps to install the batteries.
1. Gently press down on the battery
compartment cover and slide it in the
direction of the arrow to remove it.
2. Insert the batteries into the compartment
(three above and one below) as indicated
by the polarity symbols (+ and –)
marked inside.
3. Replace the cover.
Notes:
• The TV can operate for about 3.5 hours
with alkaline batteries. When the sound
level lowers or the picture becomes
unstable, replace the batteries.
• The TV's internal batteries automatically
disconnect when you connect an
adapter.
Warning: Dispose of old batteries promptly
and properly. Do not burn or bury them.
Caution: Batteries can leak chemicals that
damage your TV's electronic parts.
AC POWER
You can power the TV using a 6V, 550-mA
AC adapter and a size B Adaptaplug™
adapter (neither supplied). Both are available
at your local RadioShack store.
Cautions:
!
set to positive and its plug must fit the
TV's
DC IN 6V
that does not meet these specifications
could damage the TV or the adapter.
• Always connect the AC adapter to the TV
before you connect it to AC power.
When you finish, disconnect the adapter
from AC power before you disconnect it
from the TV.
Set the adapter's voltage switch to 6V. Insert
the Adaptaplug into the adapter's cord,
aligning + with TIP. Plug the Adaptaplug's
barrel plug into the TV's
plug the other end of the AC adapter cord into
a standard AC outlet.
Caution: Do not leave the adapter plugged
into the AC outlet or connected to the TV
when you are not using the TV.
Note: The adapter might become warm after
extended periods of use.
2
You must use a Class 2 pow-
er source that supplies 6V
DC and delivers at least 550
mA. Its center tip must be
jack. Using an adapter
jack. Then
DC IN 6V
Advertisement
