Related Manuals for Westinghouse PT50360
Summary of Contents for Westinghouse PT50360
- Page 1 INSTRUCTION MANUAL ANGLE GRINDER PT50360 INCHES 4½ 12,000 Note : Before operating this tool, read this manual and follow all safety rules and operating instructions.
- Page 2 120V and a frequency of 60Hz. The power input is 600W , the no load revolutions per minute (rpm) is 12000. Metal as well as non-metal materials can be handled with it. 1 Technical Data Types PT50360 Grinding disc (outside diameter x inside 115x22x6mm diameter x thickness): Rated voltage:...
-
Page 3: Safe Operation
3.2 Do only use blades that have been tested by the MPA! 4. If you detect any damage after unpacking the tool, it has to be checked by a qualified electrician. Disconnect it from the power supply before you open the tool. - Page 4 SAFE OPERATION 13) Do not overreach. -- Keep proper footing and balance at all times 14) Maintain tool with care. -- Keep cutting tools sharp and clean for better and safer performance. Follow instructions for lubrication and changing accessories, inspect tool cord periodically and if damaged have it repaired by an authorized service facility.
- Page 5 ADDITIONAL SAFETY INSTRUCTIONS FOR GRINDING - Ensure that blotters are used when they are provided with the bonded abrasive product and when they are required. - Ensure that the abrasive product is correctly mounted and tightened before use and run the tool at no-load for 30 seconds. a safe position, stop immediately if there is considerable vibration or if other defects are detected.
- Page 6 Features 1. Motor housing 7. Pin wrench 2. Spindle lock button 8. Depressed disc (Greater than 4mm) 3. Disc guard 9. Depressed disc (4mm or less in 4. Mounting points for the multi-position thickness) front handle 5. On/O switch with lock-on facility 10.
-
Page 7: Operation
OPERATION 1. The Line voltage must not exceed the respective specification on the electric tool by more than +10%. 2. Check the grinding disc. It must neither be damaged, wet nor cracked. For safety reasons operate the electric tool idling for one minute after having replaced a grinding disc. -
Page 8: Maintenance And Repair
MAINTENANCE AND REPAIR 1. This electric tool is operating with a very high r.p.m. Therefore, it is necessary to clean the spindle bearing regularly and to replenish or change the bearing grease. 2. The electric tool has to be regularly checked for correct operation and, if applicable, repaired. -
Page 9: Part List
PART LIST PART DESCRIPTION PART DESCRIPTION Bearing shoe Label -B Bearing Handle (F) Armature Pinio gear C ring Spring washer Screw Bearing cap Stator Bearing Fan gaide Stop pin Screw Spring Brush holder Gea box Brush Screw Screw Check ring Switch draw bar Bearing Switch lock... -
Page 10: Exploded View
EXPLODED VIEW...