Plug In The Tv; Put Batteries In The Remote; Turn On The Tv; Use The Remote Control To Complete The Assisted Setup - RCA DVR2080 User Manual

Connections & Setup

Plug in the TV

Plug the flat end of the power cable into the power jack on the side of the TV. Go to page 10 for
instructions on removing the jack panel door. Then plug the other end of the power cord into an
appropriate wall outlet. Be sure to insert the plug completely. Do not plug into an outlet
controlled by a light switch.
Note: When you first plug your TV into an outlet, the Power indicator and Backlight on
the front panel will light and blink for approximately 30 seconds and then go off during
the initialization of the TV. The TV can only be turned on after the Power indicator goes
off. This happens every time the TV is unplugged and plugged back in.
Tip
When remote batteries are low, the component
button(s) corresponding to the mode you're in
flashes when you press a button. Also, a message
might appear on the TV screen and disappear
within a few seconds. Press CLEAR and replace the
batteries to remove the message.
ON-OFF
TV
DVD VCR
SAT CAB AUX AUDIO
PIP PIP SWAP SWAP CH. CTRL CH. CTRL FREEZE
LIGHT LIGHT
CC PRESETS FAV
CC CC
FORMAT FORMAT INFO INFO
i
CLEAR CLEAR MENU MENU
C C M M
Tip
To access the setup menus, press MENU and
choose Assisted Setup.
24

Put Batteries in the Remote

•
•
•

Turn on the TV

Press TV on the remote, or press the Power button on the TV's front
panel.
Use the Remote Control to Complete
the Assisted Setup
TV
The technical term is "Navigation" – how you move through the on-screen
button
menus. The method is the same throughout the menu screens: highlight
your choice and select it.
To highlight a menu item, put the remote into TV mode by pressing the
TV button then MENU. Press the arrow buttons on the remote to highlight
one of the items listed in the menu. Use the up or down arrow button to
move up or down. Use the right or left arrow button to move right or left.
MENU button
To select the item that you've highlighted, press OK.
OK button
Arrow
buttons
Remove the battery compartment cover from the back of the remote
by pushing down on the tab and lifting cover.
Insert 2 fresh "AA" batteries. Make sure the polarities (+ and -) are
aligned correctly with the polarities inside the remote.
Replace the cover.
Note: Pressing the TV button turns on the TV and puts the remote
into TV mode. "TV mode" means that the buttons on the remote
control operate the TV's functions.
Note: Highlighted means that the menu item stands out from
other menu items on the list (appears darker, brighter, or a
different color).
Chapter 1