Operating Instructions; Lighting - Weber Genesis Silver-A Owner's Manual

Lighting

Summary lighting instructions are on the control panel.
Failure to open the lid while igniting the
barbecue's burners, or not waiting 5
minutes to allow the gas to clear if the
barbecue does not light, may result in an
explosive flare-up which can cause serious
bodily injury or death.
®
Crossover Ignition System
®
Note - The Crossover ignition system ignites the Front
burner with a spark from the igniter electrode inside the
Gas Catcher™ ignition chamber. You generate the
energy for the spark by pushing the Crossover
button until it clicks.
WARNING: Check hose before each use of
barbecue for nicks, cracking, abrasions or cuts. If
the hose is found to be damaged in any way, do
not use the barbecue. Replace using only Weber
authorised replacement hose. Contact the
Customer Service Representative in your region
using the contact information sheet provided with
your manual.
1
6
*The grill illustrated may have slight differences from the
model purchased.

Operating Instructions

DANGER
®
2
7
5
3
4
1) Open the lid.
2) Make sure all burner control knobs are turned OFF.
(Push control knob down and turn clockwise to
ensure that it is in the OFF position.)
3) Turn the cylinder on by turning the cylinder valve
anticlockwise.
WARNING: Do not lean over the open barbecue.
Keep your face and body at least one foot away
from the matchlight hole when lighting the
barbecue.
4) Push Front burner control knob down and turn to
START/HI.
5) Push the Crossover
it clicks each time.
6) Check that the burner is lit by looking through the
matchlight hole on the front of the cooking box. You
ignition
should see a flame.
WARNING: If the burner does not light, turn the
Front burner control knob to OFF and wait 5
minutes to let the gas clear before you try again or
try to light with a match.
®
7) After the FRONT burner is lit you can turn on the
other burner or burners.
Note - Always light the FRONT burner first. The other
burner or burners ignite from the FRONT burner.
To Extinguish
Turn gas supply OFF at the source, then push down
and turn each burner control knob clockwise to the
OFF position.
22
®
ignition button several times, so