Self Test - BIXOLON SRP-330II User Manual

2. Self Test

The self-test checks whether the printer has any problems. If the printer does not function
properly, contact your dealer. The self-test procedure is as follows:
2-1 Check whether the paper is inserted correctly.
2-2 Turn on the printer while depressing the Feed button. Self-diagnostics will begin.
2-3 The printer prints the current status of the printer such as the version of the ROM and
DIP switch setting.
2-4 The printer prints the current status and stops after printing the following statement.
(PAPER indicator keeps blinking.)
2-5 Press the FEED button for less than 1 second to perform "Continuous SELF-TEST".
Hold down the FEED button for 1 second or longer to perform "VMSM Selection".
2-5-1 Self-Test
2-5-1-1 If you press the FEED button for less than 1 second, the printer will print in the
preset character type.
2-5-1-2 The self-test completes automatically and cuts the paper after printing the following
line.
2-5-1-3 The printer goes into standby mode when the self-test is complete.
2-5-2 Virtual Switch Setting Mode
2-5-2-1 When the printer goes into virtual switch-setting mode, the following lines will be
printed.
Rev. 1.00
SELF-TEST PRINTING.
SELECT MODES BY PRESSING FEED BUTTON.
Continuous SELF-TEST : Less than 1 second
VMSM Selection
*** COMPLETED ***
** VMSM Selection **
0: Exit and reboot printer
1: Print current settings
2: Set Print Density
3: Set Print Speed
4: Set Cutting mode
5: Set External Buzzer after cutting
6: Set Internal Buzzer after cutting
7 or more: None
: 1second or more
- 20 -
SRP-330II/332II