Layout Contents - Fujitsu D1271 Technical Manual

3. HARDWARE SETUP

3.2 Layout Contents

Motherboard Settings
1) JEN
2) DIP_SW 5–8
3) DIP_SW 1-4
4) R56
5) LAN-EN
6) SCSI_EN
Expansion Slots/Sockets
1) DIMM 1/2/3/4
2) Socket 370
3) PCI 1/2/3/4
Connectors
1) PS2KBMS
2) PS2KBMS
3) USB
4) PRINTER
5) COM1/COM2
6) VGA
7) RJ-45
8) HDLED
9) FLOPPY
10) PRIMARY IDE
SECONDARY IDE
11) CHA/CHB
12) WOL_CON
13) WOR
14) PWR/CPU/CHA_FAN
15) USBPORT
16) IR
17) CHASSIS
18) ATXPWR
19) SMB/BP_SMB
20) PWR.LED (PANEL)
21) SPEAKER (PANEL)
22) MSG.LED (PANEL)
23) SMI (PANEL)
24) PWR.SW (PANEL)
25) RESET (PANEL)
D1271/D1291 CUV-LSV/CUV-LV User's Manual
p. 17 JumperFree Mode Setting (Disable/Enable)
p. 18 CPU External Frequency Selection
p. 19 CPU Core:BUS Frequency Multiple Selection
p. 21 Clear RTC RAM
p. 21 LAN Setting
p. 22 SCSI Setting (optional)
p. 24 DIMM Support
p. 25 CPU Support
p. 27 32-bit PCI Bus Expansion Slots
p. 29 PS/2 Mouse Port (6 pin-female)
p. 29 PS/2 Keyboard Port (6-pin female)
p. 30 Universal Serial Bus Ports1 & 2 (Two 4-pin female)
p. 30 Parallel Port (25-pin female)
p. 30 Serial Ports (9-pin /10-1 pin male)
p. 31 Monitor Output Port (15-pin female)
p. 31 Fast Ethernet LAN Connectors (Two RJ-45)
p. 32 IDE and SCSI Activity LED (2-pin)
p. 32 Floppy Disk Drive Port Connector (34 pins)
p. 33 IDE Connectors (Two 40-1 pins)
p. 34 Ultra160 Wide SCSI Connectors (Two 68-pin)
p. 35 Wake-On-LAN Connector (3-pin)
p. 35 Wake-On-Ring Connector (2-pin)
p. 36 Power, CPU, and Chassis Fan Connectors (Three 3-pin)
p. 36 USB2 Header (10-1 pins)
p. 37 Infrared Module Connector (5-pin)
p. 37 Chassis Intrusion Lead (2-pin)
p. 38 ATX Power Supply Connector (20 pins)
p. 38 SMBus Connectors (Two 5-1 pins)
p. 39 System Power LED Lead (3-pin)
p. 39 System Warning Speaker Connector (4-pin)
p. 39 System Message LED (2-pin)
p. 39 System Management Interrupt Lead (2- pin)
p. 39 ATX / Soft-Off Switch Lead (2-pin)
p. 39 Reset Switch Lead (2-pin)
15