NETGEAR GS305P Installation

Installation
5-Port PoE Gigabit Ethernet Unmanaged Switch
GS305P
Package Content
• Switch
• Power adapter (localized to the country of sale)
• Wall installation kit
• Rubber feet
• Installation guide
Step 1. Connect the equipment.
Connect Port 5 on the switch to your router. Connect Ports 1
switch to your power over Ethernet (PoE) or non-PoE devices.
Router
GS305P
PoE VoIP phone
PoE security cameras
PoE access point
Sample connections
Step 2. Connect to power.
Step 3. Check the status.
– 4 on the
Power LED Left Port LEDs (Ports 1–5)
On
Internet
Off
Connect Port 5 to the router
PoE Max LED
The maximum PoE power that the GS305P switch can deliver to all attached powered devices
(PDs) is 55.5 Watts total, with a maximum power to each port of 15.4 Watts. (For more
information, see PoE Considerations.)
The PoE Max LED indicates the status of the PoE power that the switch can deliver to all
attached PDs.
Less than 7W of PoE power is available on the switch (the LED is on).
The PoE Max LED was active in the previous two minutes (the LED is blinking).
Sufficient (more than 7W of) PoE power is available on the switch (the LED is off).
Right PoE LEDs (Ports 1–4)
1000 Mbps link PoE in use
PoE halted (see PoE
100 or 10 Mbps link
Troubleshooting)
No PoE use (off)
Activity (blinking)
No link (off)