Subaru 2003 LEGACY Quick Reference Index page 77

DIAGNOSTIC CHART WITH DIAGNOSTIC TROUBLE CODE (DTC)
Step
1 CHECK SEAT BELT PRETENSIONER.
1) Turn the ignition switch OFF, disconnect
the battery ground cable, and wait more
than 20 seconds.
2) Disconnect the connector (AB26) from the
seat belt pretensioner (RH). <Ref. to SB-7,
Front Seat Belt.>
3) Connect the connector (1F) in test harness
F to (AB26).
4) Connect the airbag resistor to connector
(3F) in test harness F.
5) Connect the battery ground cable, and turn
the ignition switch ON.
Does the airbag warning light operate prop-
erly?
2 CHECK SIDE AIRBAG HARNESS (RH).
1) Turn the ignition switch OFF, disconnect
the battery ground cable, and wait more
than 20 seconds.
2) Disconnect the airbag resistor from the test
harness.
3) Disconnect the connector (AB25) from
(AB24).
4) Disconnect the connectors (AB17) and
(AB18) from the airbag control module.
<Ref. to AB-17, Airbag Control Module.>
5) Connect the connector (1I) in test harness
I2 to the connector (AB18).
6) Connect the battery ground cable and turn
the ignition switch ON.
7) Measure the voltage between connector
(3I) in test harness I2 and the chassis
ground.
Connector & terminal
(3I) No. 6 (+) — Chassis ground ( − − − − ):
(3I) No. 8 (+) — Chassis ground ( − − − − ):
Is the measured value less than the speci-
fied value?
Value
Operates properly.
1 V
AB-75
AIRBAG SYSTEM (DIAGNOSTICS)
Yes
Replace seat belt Go to step 2.
pretensioner (RH).
<Ref. to SB-7,
Front Seat Belt.>
Replace the airbag Replace side air-
control module. bag harness.
<Ref. to AB-17, <Ref. to AB-16,
Airbag Control Side Airbag Har-
Module.> ness.>
No