Optional Accessories; Battery Removal/Installation - Hitachi WM 10DBL Handling Instructions Manual

CHARGER
Model
Charging voltage
Weight

OPTIONAL ACCESSORIES

(Sold separately)
1. Battery (BCL1030A / BCL1030)
2. Plus driver bit
Bit No.
No. 2
No. 3
3. Hexagonal socket
Part Name
5 mm Hexagonal socket
6 mm Hexagonal socket
5/16" Hexagonal socket
8 mm Hexagonal socket
Engraved characters
4. Drill chuck adapter set: Code No. 321823
Use drill bits available on the local market.
Optional accessories are subject to change without notice.
UC10SL2
10.8 V
0.35 kg
Code No.
992671
992672
Engraved
L B Code No.
characters
8 65 8 996177
10 65 10 985329
12 65 12 996178
13 65 13 996179
APPLICATION
Driving and removing of small screws, small bolts,
machine screws, wood screws, tapping screws, etc.
Drilling of various woods.
Drilling of various metals.

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the handle tightly and push the battery latch to
remove the battery (see Figs. 1 and 2).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2).
CHARGING
Before using the Electronic pulse driver, charge the
battery as follows.
1. Connect the charger's power cord to the receptacle.
When connecting the plug of the charger to a
receptacle, the pilot lamp will blink in red
(At 1-second intervals).
2. Insert the battery into the charger.
Firmly insert the battery into the charger till it contacts
the bottom of the charger as shown in
Fig. 3.
3. Charging
When inserting a battery in the charger, the pilot
lamp will light up continuously in red.
When the battery becomes fully recharged, the pilot
lamp will blink in red (At 1-second intervals).
(See Table 1)
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown in
Table 1, according to the condition of the charger or
the rechargeable battery.
English
6