Gravely Rapid M 985403 Owner's/Operator's Manual page 13

Locking
Latch
Parking Brake /
Clutch Lever
Differential Lock
Locks the differential so both wheels are
locked together to increase traction.
Push in the differential lock to lock the
wheels. Pull out the differential lock to unlock
the wheels and to aid in turning the machine.
NOTE: The differential lock can be engaged,
and disengaged, while the machine is moving
or when stopped.
Handlebar Height Adjuster
NOTE: Do not adjust the handlebar height
while driving the unit.
Pull out the handlebar height adjuster and
raise or lower the handlebar to a comfortable
height and then push in the adjuster. Move
the handlebar up or down to lock the
handlebar into position.
Figure 6
Attachment Locking Pin
Open the locking pin to install or remove
attachments. Close the locking pin to secure
the attachment to the unit.
IMPORTANT: MAKE SURE the locking pin is
completely seated prior to engaging the PTO.
Installing Attachments
WARNING: The engine must off
and the parking brake set, prior to
installing attachments.
NOTE: Some attachments will require the two
wheel tractor attachment adaptor kit
78510700.
1. Clean dirt and debris from the
attachment and PTO socket.
2. Grease the splines of the PTO shaft and
the PTO socket.
3. Open the locking pin.
4. Push the attachment into the PTO
socket.
5. Close the locking pin to secure the
attachment.
IMPORTANT: MAKE SURE the locking pin is
completely seated prior to engaging the PTO.
Removing Attachments
WARNING: The engine must be
off and the parking brake set, prior
to removing attachments.
1. Open the locking pin.
2. Remove the attachment.
Hydraulic Bypass Valve
WARNING: DO NOT disengage
the transmission on a slope.
The bypass valve allows the hydraulic
transmission to freewheel or to drive. Push
the bypass valve down to engage the
transmission. Pull the bypass valve up to
disengage the transmission.
GB - 13