Advertisement
Quick Links
DSC 500
Digital Moisture Analyzer
Simple to Use
Compact & Easy to Clean
No Complicated Buttons or Menus
Quick Guide
Toll Free: 800-726-5883
14639 Arminta Street * Panorama City, CA 91402
Data Support Co., Inc * Toll Free: 800-726-5883 * Tel: 818-988-7499 * Fax: 818-988-7671 * website: www.dsctest.com
Advertisement
Summary of Contents for DSC 500
- Page 1 DSC 500 Digital Moisture Analyzer Simple to Use Compact & Easy to Clean No Complicated Buttons or Menus Quick Guide Toll Free: 800-726-5883 14639 Arminta Street * Panorama City, CA 91402 Data Support Co., Inc * Toll Free: 800-726-5883 * Tel: 818-988-7499 * Fax: 818-988-7671 * website: www.dsctest.com...
- Page 2 DSC 500 Quick Reference Operating Instructions. 1. Turn on the unit by pressing the “On/Off” Button. (This will be displayed on the screen) 2. Open up the hood and place (1) Aluminum Dish on the pan support. 3. Place one (1) or two (2) Glass Fiber Pads in the Aluminum Dish (if...
- Page 3 4. Press the Tare Button to zero-out the reading. 5. Place 3~5 grams of sample on the pad. (The weight will be displayed on the screen) 6. Remove the (2) Glass Fiber Pads from the Aluminum Dish. Spread the sample as evenly and as thinly as possible. 7.
- Page 4 8. Press the pad gently together with the palms of your hands to avoid separation or curling during the test. 9. Flip the pads over in such a way that the pad where the sample was spread will be on top. 10.
- Page 5 11. Close the cover and Press the “Start / Stop button 12. Once the test is done, the %Moisture and %Solids Reading will be displayed on the screen and a beeping sound will be heard. (Average test time is about 18 minutes). 70.08 % Moisture 29.92 % Solids...
- Page 6 4. To run another test, press the TARE button to reset the machine, then follow the steps above. Be sure to record the reading before pressing the tare button as it will clear the reading on the screen. WARNING: Use the tweezers to remove the hot aluminum dish after a test to prevent any burn injury.
- Page 7 DATA SUPPORT COMPANY, INC. HFT 500 Weight Calibration Procedure 1. Make sure nothing in on the pan support. 2. Press and Release the TARE button to zero-out the reading. Zero-out Reading 3. Press and Hold the calibration button until “CAL” is displayed.
- Page 8 4. Place the 50 gm calibration weight at the center of the pan support. The 50.00 g display will stop blinking. 5. Remove the 50 g calibration weight, and the reading will show 0.00g. 6. Weight Calibration is now complete.