Access The Software Module Console; Access The Asa 5506W-X Wireless Access Point Console - Cisco ASA Series Getting Started

Access the Software Module Console

Procedure
To return to the switch CLI, type exit from the ASASM privileged or user EXEC mode. If you are in a
configuration mode, enter exit repeatedly until you exit the Telnet session.
You return to the switch prompt:
asasm# exit
Router#
Note
Access the Software Module Console
If you have a software module installed, such as the ASA FirePOWER module on the ASA 5506-X, you can
session to the module console.
You cannot access the hardware module CLI over the ASA backplane using the session command.
Note
Procedure
From the ASA CLI, session to the module:
session {sfr | cxsc | ips} console
Example:
ciscoasa# session sfr console
Opening console session with module sfr.
Connected to module sfr. Escape character sequence is 'CTRL-^X'.
Cisco ASA SFR Boot Image 5.3.1
asasfr login: admin
Password: Admin123

Access the ASA 5506W-X Wireless Access Point Console

To access the wireless access point console, perform the following steps.
Procedure
Step 1
From the ASA CLI, session to the access point:
session wlan console
CLI Book 1: Cisco ASA Series General Operations CLI Configuration Guide, 9.5
8
You can alternatively escape the Telnet session using the escape sequence Ctrl-Shift-6, x; this escape
sequence lets you resume the Telnet session by pressing the Enter key at the switch prompt. To
disconnect your Telnet session from the switch, enter disconnect at the switch CLI. If you do not
disconnect the session, it will eventually time out according to the ASASM configuration.
Getting Started