15. Reach through the inspection hole and unhook the
throttle wire
16. Compress the plasic clips and remove the wire.
17. If the product is equiped with a speed control unit,
reach through the inspection hole and unhook the
speed control wire from the gearbox.
18. Compress the plasic clips and remove the wire.
19. Use a circlip plier to separate the plastic stops.
20. Pull out the rear axle with the gearbox.
4.5 To remove the rear axle (without
drive)
Use bent pliers to pry apart the plastic stops and pull out
the rear axle.
4.6 To replace the drive belt
1. Lock the blade with a wooden block. Remove the
blade screw and the washer.
2. Remove the blade support.
Repair instructions
English – 13