Yard-Man 950 series Owner's Manual page 15

Rear Wheels Adjustment Lever
Baffle
Figure 21
9. Tilt the trans mission for ward and loosen
the idler pul ley bolt and locknut ½ turn
using two 7/16" wrenches.
10. Using a pair of pli ers, pull back and ro tate
belt keeper bracket from the slot on idler
pul ley.
11. Slide the belt out from be tween the belt
keeper bracket and the idler pul ley. See
Fig ure 22.
12. Squeeze the belt to gether and push belt
forward. Press the con trol arm in ward to -
wards the deck and re move the six speed
cable from the slot. See Fig ure 23.
Transmission
Pulley
Belt
Belt Keeper
Bracket
Idler Pulley
Bracket
Idler Pulley
Bolt and
Locknut
Figure 22
Mower is shown tipped on en gine for clarity.
Remember, only tip mower back on its han -
dle with the spark plug facing up.
Control
Hex
Bolt
Figure 23
Figure 24
13. Pivot the con trol arm down away from the
14. Lift off the lower pul ley as sembly and re -
15. Place the new belt over the trans mission
Transmission
16. Place belt be tween idler pul ley and the
Figure 25
15
Six-Speed
Belt
Cable Slot
Arm
Six-Speed
Cable Slot
pulley and belt. See Fig ure 24.
move the old be lt from around the
crankshaft. See Figure 25.
pulley. Start the belt in pul ley groove and
rotate pulley until belt is seated in trans-
mission pul ley. See Fig ure 25.
belt keeper bracket.
Lower Pulley
Half
Control
Arm
Crankshaft
Belt