Electrolux ENN2701AOW User Manual page 11

Problem
The appliance is noisy.
The lamp does not work.
The compressor operates
continually.
Water flows inside the re‐
frigerator.
Water flows on the floor.
Possible cause
The mains plug is not
connected to the mains
socket correctly.
There is no voltage in the
mains socket.
The appliance is not sup‐
ported properly.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed
correctly.
The water drainage plug
is not correctly posi‐
tioned.
Food products are not
wrapped properly.
Temperature is set incor‐
rectly.
The water outlet is clog‐
ged.
Food products prevent
that water flows into the
water collector.
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
ENGLISH
Solution
Connect the mains plug to
the mains socket correctly.
Connect a different electrical
appliance to the mains sock‐
et. Contact a qualified elec‐
trician.
Check if the appliance
stands stable.
Close and open the door.
Refer to "Replacing the
lamp".
Refer to "Operation".
Wait some hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products bet‐
ter.
Refer to "Operation" .
Clean the water outlet.
Make sure that food prod‐
ucts do not touch the rear
plate.
Attach the melting water out‐
let to the evaporative tray.
11