Hose Connected; To Disconnect The City Water Connection - Roadtrek CS Adventurous 2016 Owner's Manual

HOWTO: Potable Water Use
Attaching pressure
regulator to city water

To disconnect the city water connection:

• • Turn off the external water source.
• • Open a faucet to relieve the pressure in the system. Failure to do so will not damage your vehicle, but may result in an
unexpected shower when you disconnect the hose. The galley sink is a convenient place to do this.
• • Make sure the the city tank fill valve is closed (handle across the line).
• • Remove the hose from the city water connection, and replace the cap on the fill connection.
• • Disconnect the hose from the supply faucet and stow it inside your vehicle. Connecting the ends is a handy way to prevent
dirt or other contaminants from entering the hose while stored, and residual water from leaking out.
If you hear your pump running constantly, and water pressure is low inside the vehicle after disconnecting from an
external water source, it is because you have not properly positioned the city water valve. Make sure the black plastic
handle is perpendicular to (across) the water line when your water system is in self-contained mode.
fill location

Hose connected

© 2016 by Erwin Hymer Group North America, Inc.
105