Panel Descriptions; Front Panel; Rear Panel - Roland PM-100 Owner's Manual

Panel Descriptions

Front Panel

1
V-drums INPUT jack
Connect the drum sound module to this jack.
2
LINE INPUT jacks
Connect an audio player or electronic musical instrument here,
and hear it along with the drums.
Both stereo phone 1/4" and stereo mini 1/8" jacks are provided,
and can be used simultaneously.
Pin assignment of INPUT (V-Drums, LINE) jacks
Both mono and stereo are supported.
L
R
GND
* This accepts 1/4" stereo phone plug. However, the speaker is
mono.

Rear Panel

8
8
AC IN jack
Connect the included Power cord here. Plug it firmly in, so that the
cable does not accidentally become disconnected.
4
1 2
SIGNAL
GND
GND
3 4 5
3
[V-Drums VOLUME] knob
Adjusts the volume of the device connected to the V-Drums
INPUT jack.
4
[LINE VOLUME] knob
Adjusts the volume of the device connected to the LINE INPUT
jacks.
5
[BASS] knob
Adjusts the level of the Low frequency.
6
[TREBLE] knob
Adjusts the level of the High frequency.
7
[POWER] switch/POWER indicator
This switch turns the power on/off.
When the power is on, the indicator will be lit.
DIRECT OUT (PM-200 only)
10
9
DIRECT OUT L, R connectors
Connect this to your PA system or recorder.
The signals that are input to the INPUT jacks (V-Drums, LINE) are
output without change.
9
Pin assignment of DIRECT OUT connectors
1: GND
10
[DIRECT OUT] switch
When the signal that is input to the V-Drums INPUT jack is output
from the DIRECT OUT jacks, this switch selects whether the output
is stereo or mono.
* This switch does not affect the signal that is input to the LINE
INPUT jacks.
STEREO
MONO
6 7
2: HOT
3: COLD
When the input is stereo When the input is mono
Signal (mono) is output from
Stereo output
Same signal (mono) is output from the L and R channels
the L channel only