Bypassing Nat - Cisco FirePOWER ASA 5500 series Configuration Manual

Bypassing NAT

To redirect Telnet traffic from the security appliance outside interface (10.1.2.14) to the inside host at
10.1.1.15, enter the following command:
hostname(config)# static (inside,outside) tcp 10.1.2.14 telnet 10.1.1.15 telnet netmask
255.255.255.255
If you want to allow the preceding real Telnet server to initiate connections, though, then you need to
provide additional translation. For example, to translate all other types of traffic, enter the following
commands. The original static command provides translation for Telnet to the server, while the nat and
global commands provide PAT for outbound connections from the server.
hostname(config)# static (inside,outside) tcp 10.1.2.14 telnet 10.1.1.15 telnet netmask
255.255.255.255
hostname(config)# nat (inside) 1 10.1.1.15 255.255.255.255
hostname(config)# global (outside) 1 10.1.2.14
If you also have a separate translation for all inside traffic, and the inside hosts use a different mapped
address from the Telnet server, you can still configure traffic initiated from the Telnet server to use the
same mapped address as the static statement that allows Telnet traffic to the server. You need to create
a more exclusive nat statement just for the Telnet server. Because nat statements are read for the best
match, more exclusive nat statements are matched before general statements. The following example
shows the Telnet static statement, the more exclusive nat statement for initiated traffic from the Telnet
server, and the statement for other inside hosts, which uses a different mapped address.
hostname(config)# static (inside,outside) tcp 10.1.2.14 telnet 10.1.1.15 telnet netmask
255.255.255.255
hostname(config)# nat (inside) 1 10.1.1.15 255.255.255.255
hostname(config)# global (outside) 1 10.1.2.14
hostname(config)# nat (inside) 2 10.1.1.0 255.255.255.0
hostname(config)# global (outside) 2 10.1.2.78
To translate a well-known port (80) to another port (8080), enter the following command:
hostname(config)# static (inside,outside) tcp 10.1.2.45 80 10.1.1.16 8080 netmask
255.255.255.255
Bypassing NAT
This section describes how to bypass NAT. You might want to bypass NAT when you enable NAT control.
You can bypass NAT using identity NAT, static identity NAT, or NAT exemption. See the
NAT when NAT Control is Enabled" section on page 17-9
This section includes the following topics:
•
•
•
Configuring Identity NAT
Identity NAT translates the real IP address to the same IP address. Only "translated" hosts can create
NAT translations, and responding traffic is allowed back.
Cisco Security Appliance Command Line Configuration Guide
17-28
Configuring Identity NAT, page 17-28
Configuring Static Identity NAT, page 17-29
Configuring NAT Exemption, page 17-31
Chapter 17
for more information about these methods.
Applying NAT
"Bypassing
OL-10088-01