Table of Contents
Advertisement
To quickly put the camera into operation:
1.
Prepare the mounting surface.
2
Mount the camera on the mounting surface using the
appropriate fasteners. See "Mounting the IP thermal
bullet camera" below.
3.
Set up the camera's network and streaming parameters
so that the camera can be controlled over the network.
For further information, please refer to the "TruVision IP
Thermal Camera Configuration Manual".
4.
Program the camera as appropriate for its location. For
further information, please refer to the "TruVision IP
Thermal Camera Configuration Manual".
Accessing the SD card
Insert a Micro SD card with up to 128GB to use the camera as
an additional recording device, or as a backup in case of
failure of communication with the network video recorder. The
card is not supplied with the camera.
Recorded video and log files can be accessed via the web
browser or via TruVision Navigator.
Mounting the IP thermal bullet camera
Mount the camera on a ceiling or wall.
To mount the IP thermal bullet camera:
1.
Use the supplied template to mark out the mounting area.
Drill the screw holes on the ceiling or wall. If you need to
route the cables from the camera base, drill a cable hole
in the ceiling or wall.
Installation Guide
7
Hide quick links:
Advertisement
Table of Contents
