Advertisement
Quick Links
EXHIBIT 7
SECTION 2.1033 (1a)
Information to User - FCC Part 15. To be included in the user's manual/operating instructions.
Part 15.21 Statement for all intentional and unintentional radiators shall be included.
" This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation. "
USERS MANUAL / OPERATING INSTRUCTIONS
SECTION 2.1033 (1a)
PLEASE SEE THE II
( Installation Instructions )
ON THE NEXT 4 PAGES.
CFS8DL5805BDV-1
Advertisement
Related Manuals for ADEMCO 5805BDV
Summary of Contents for ADEMCO 5805BDV
-
Page 1: Installation Instructions
EXHIBIT 7 USERS MANUAL / OPERATING INSTRUCTIONS CFS8DL5805BDV-1 SECTION 2.1033 (1a) SECTION 2.1033 (1a) Information to User - FCC Part 15. To be included in the user’s manual/operating instructions. Part 15.21 Statement for all intentional and unintentional radiators shall be included. “... -
Page 2: General Information
Observe polarity to prevent damage to the unit or to the battery. The 5805BDV is a four-button wireless key that permits the user to control the alarm system remotely. It is a two- way device that sends commands (e.g., Arm, Disarm, Panic) to the alarm system, and receives current status from the system. - Page 3 The 5805BDV transmits a special signal to the receiver. • Enter the serial number through Compass downloader After 2 seconds, the unit will shut down. The 5805BDV is software as applicable. now in High-Security mode. Be sure to include the loop number of each button during programming (see loop assignments on previous page).
- Page 4 To Request System Status Low-Battery Indication Because the 5805BDV is a two-way device, users can check the When the unit goes into a low battery condition, its volume level system status before arming or disarming their system. To check will drop, and the LED will no longer flash when a button is system status, press and release any button momentarily.
- Page 5 NOTE: The following table contains the zone descriptors that can be annunciated by the 5805BDV. The control panel and transceiver must be capable of transmitting these same descriptors to the 5805BDV. Refer to the panel’s Installation and Setup Guide for zone descriptor words that match the words in the following table. The 5805BDV cannot annunciate Custom Words or any words that are not contained in this table.