Radio Shack XMODS 60-8506 Manual

XMODS Custom RC
TM
All Wheel Drive Kit
60-8506
Upgrade your XMODS custom RC from standard two-wheel drive to all-wheel drive for improved traction
and cornering. Before installing this kit, turn off your vehicle and controller, and detach the car body.
The All-Wheel Drive kit includes:
Rear differential gear
Drive shaft cone gear
Front left and right steering assembly w/differential gear
Left and right rear arms (optional installation)
Tube of grease
Preparing for Your All-Wheel Drive Upgrade
1
Use the lug wrench supplied in your XMODS
detach the front lug nuts and wheels.
Front Section All-Wheel Drive Installation
1
Loosen and remove each screw beneath the right and left
front knuckles. Loosen and remove the four screws
beneath the front arm base.
©
2003 RadioShack Corporation
All Rights Reserved.
RadioShack and RadioShack.com are trademarks
used by RadioShack Corporation.
www.xmodsRC.com
Note: Although the front and rear differential gears appear similar,
2
Starter Kit to Loosen and remove each damper screw and detach the
TM
right and left front and rear dampers.
Tip: You may find it useful
to remove the antenna
from the chassis.
2
Unscrew and remove the two rear screws on the front upper
deck. Lift up and remove the front upper deck along with
the left and right steering assemblies.
they are not. DO NOT USE THEM INTERCHANGEABLY! In the
event of mix up, carefully unscrew one gear into two halves.
If the gear has metal bearings inside, this is the rear
differential. If not, the gear is the front differential.
Note: You will not need the front left and right steering
assemblies unless you encounter a need to remove
the all-wheel drive upgrade.
1