Page 20
1 Important • Apparatus shall not be exposed to dripping or splashing. • Do not place any sources of danger on the apparatus (e.g. liquid filled objects, lighted • Read these instructions. candles). • Heed all warnings. • The USB socket is for data transmission • Follow all instructions. only. • Do not use this apparatus near water. • Where the plug of the Direct Plug-in • Do not block any ventilation openings. Adapter is used as the disconnect device, Install in accordance with the the disconnect device shall remain readily manufacturer’s instructions. operable. • Do not install near any heat sources such as radiators, heat registers, stoves, or Warning other apparatus (including amplifiers) that produce heat.
2 Your Docking Overview of the main unit Speaker Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the bottom of the apparatus. Write the numbers here: Model No. __________________________ Serial No. ___________________________ Introduction With this docking speaker, you can a Dock for the iPod/iPhone •...
3 Get started Option 2: Battery power Caution Always follow the instructions in this chapter in • Risk of explosion! Keep batteries away from heat, sequence. sunshine or fire. Never discard batteries in fire. • Remove batteries if they are exhausted or will not be used for a long time. • Batteries contain chemical substances, so they should Connect power be disposed of properly. This docking speaker can be powered by either Open the battery compartment. AC power or batteries. Insert 4 x 1.5V AA batteries with correct polarity (+/-) as indicated. Option 1: AC power Close the battery compartment. Caution • Risk of product damage! Make sure that the power supply voltage matches the voltage printed on the bottom of the unit. •...
Switch to standby mode • iPhone 3GS • iPhone 3G The docking speaker switches to standby mode • iPhone in the following situation: • Press again; Listen to the iPod/iPhone • The speaker is idle for 15 minutes when powered by AC supply. Philips DockStudio app brings a suite of new • The iPod/iPhone or external audio device features to your docking speaker. To enjoy more is disconnected when the speaker is features, you are recommended to install the operated on batteries. free DockStudio app. » The / LED indicators light off. Press to turn the docking speaker on. » The LED indicators light up. Insert the iPod/iPhone into the dock.
Page 24
For first-time use, you will be asked to Charge the iPod/iPhone install DockStudio app on your iPod/ iPhone. Note Tap [Yes] (yes) to accept the installation • request. If the docking speaker is operated on the batteries, you cannot charge your iPod/iPhone. Follow the on-screen instructions to complete the installation. When the docking speaker is connected to AC power, the docked iPod/iPhone begins to charge. • For certain iPod models, it may take up to a minute before the charging indication appears. Launch the app after the installation. Sync iPod/iPhone with PC Play audio on your iPod/iPhone. » Audio comes out through this docking Note speaker. • Make sure that iTunes has been configured properly in your PC.
Page 25
Play from an external device Adjust volume To adjust volume: With this docking speaker, you can also enjoy audio from an external device such as an MP3 • Press +/- on your docking speaker; or player. • Adjust the volume control of your iPod/ iPhone or external device. Note • Make sure that no iPod/iPhone is docked in the speaker. Press to turn the docking speaker on. Connect the MP3 link cable (not supplied) • the MP3-LINK socket at the back of the docking speaker. • the headphone socket on an external device. » The docking speaker switches to MP3 link mode automatically. Play audio on the device (see the device’s user manual). • If the docking speaker is powered by batteries, the volume is lower than that by AC supply.
2 X 5 W RMS To keep the warranty valid, never try to repair the system yourself. General information If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains Power supply Model: AS190-090- unsolved, go to the Philips web site - AC Power AA190 (Philips); (www.philips.com/support). When you contact Input: 100-240 V ~, Philips, ensure that the apparatus is nearby 50/60Hz, 0.7A; and the model number and serial number are Output: 9 V 1.9 A;...
Page 27
7 Notice Please visit www.recycle.philips.com for additional information on a recycling center in your area. Environmental information Any changes or modifications made to this All unnecessary packaging has been omitted. device that are not expressly approved by We have tried to make the packaging easy to Philips Consumer Lifestyle may void the user’s separate into three materials: cardboard (box), authority to operate the equipment. polystyrene foam (buffer) and polyethylene (bags, protective foam sheet.) Your system consists of materials which can be recycled and reused if disassembled by “Made for iPod” and “Made for iPhone” a specialized company. Please observe the mean that an electronic accessory has been local regulations regarding the disposal of designed to connect specifically to iPod or packaging materials, exhausted batteries and old iPhone respectively, and has been certified by equipment. the developer to meet Apple performance standards. Apple is not responsible for the...