Cisco Nexus 5500 Series Configuration Manual page 41

Using the Cisco NX-OS Setup Utility
Step 9
Enter yes (yes is the default) to configure the IPv4 default gateway (recommended) and enter the IPv4 address for the
default gateway.
Example:
Configure the default-gateway: (yes/no) [y]: yes
IPv4 address of the default-gateway: default_gateway
Step 10
Enter yes (yes is the default) to enable the Telnet service.
Example:
Enable the telnet service? (yes/no) [y]: yes
Step 11
Enter yes (no is the default) to enable the SSH service.
Example:
Enabled SSH service? (yes/no) [n]: yes
a) Enter the SSH key type that you would like to generate.
Example:
Type the SSH key you would like to generate (dsa/rsa/rsa1)? dsa
b) Enter the number of key bits within the specified range.
Example:
Enter the number of key bits? (768 to 2048): 768
Step 12
Enter yes (no is the default) to configure the NTP server and enter the IPv4 address for the NTP server.
Example:
Configure NTP server? (yes/no) [n]: yes
NTP server IP address: ntp_server_IP_address
Step 13 Enter yes (yes is the default) to configure basic Fibre Channel configurations.
Example:
Enter basic FC configurations (yes/no) [n]: yes
Step 14 Enter shut (shut is the default) to configure the default Fibre Channel switch port interface to the shut (disabled) state.
Example:
Configure default physical FC switchport interface state (shut/noshut) [shut]: shut
Step 15 Enter on (on is the default) to configure the switch port trunk mode.
Example:
Configure default physical FC switchport trunk mode (on/off/auto) [on]: on
Step 16 Enter permit (deny is the default) to deny a default zone policy configuration.
OL-30890-01
Cisco Nexus 5500 Series NX-OS Fundamentals Configuration Guide, Release 7.x
Initial Configuration
25