Page 3
10 . Do not carry this unit by cord or use cord as handle . DANGER 11 . Never operate this unit if it has a damaged cable, if it is not working properly, or if it To reduce the risk of electric shock, burns, fire or injury: has been dropped or damaged, or dropped into water .
FCC INFORMATION 9 . For best performance, it is recommended that you operate the drone in light wind conditions, as wind can greatly affect the performance of the aircraft . Caution: Changes or modifications not expressly approved by the party responsible for CAUTION: DO NOT ATTEMPT TO FLY THE DRONE IF THERE IS RAIN, SNOW, compliance could void the user's authority to operate the equipment.
LI-PO BATTERY WARNING CHARGING THE DRONE'S BATTERY This device contains a Lithium-Polymer battery . The battery must be recycled or disposed The 3-in-1 Water Drone includes a rechargeable Lithium-Polymer battery . Charge the of properly . Contact your local waste management office for information on battery battery before first use .
DRONE PARTS AND CONTROLS CONTROLLER PARTS AND CONTROLS Rotor Cap Rotor (A) Antenna Body Rotor (B) Mode Buttons Power LED Body Lights Power Switch Motor Direction Control Stick Speed Control Stick Speed Trim Forward/Backward Trim Rotor (A) Direction Trim Crab Trim Speed 40% Speed 100% Speed 60%...
SYNCH THE DRONE WITH THE CONTROLLER FLYING YOUR DRONE Ensure that the battery has been fully charged (see Page 7) . It is very important to spend time learning to control your drone in a safe environment before flying it in more challenging conditions . Practice the following moves until you are Place the drone on a flat surface .
SELECTING AIR OR LAND/WATER MODE TRIMMING THE DRONE You can operate the drone in the air, on land, or in the water . Press either Mode Button to To ensure that your drone can fly straight and level, you must calibrate its movements so select your mode .
GYRO CALIBRATION STUNT PLAY If the drone is experiencing difficulty flying or is behaving erratically, the gyroscopes may When the drone is in land and sea mode and you are operating at high speed (with the need to be recalibrated . Do not attempt to do this while flying . Safely land the drone Speed 80% or 100% button activated), if you press the Speed Control Stick (the left before attempting this procedure .
CARE AND MAINTENANCE PROBLEM POSSIBLE CAUSE SOLUTION • Clean with a soft, damp cloth . Drone moves forward The drone was not level during Shut down and restart the during hover, even after trim power up, or the elevator stick drone .
ONE (1) YEAR LIMITED WARRANTY suppliers other than Brookstone may provide their own warranties to the purchaser, but Brookstone, in so far as permitted by law, provides these products “as is . ” Brookstone ® warrants this product against defects in materials and/or workmanship...