Scanning With The Integrated Laser Scanner And 1D Linear Imager - Intermec CK30 User Manual

Hide thumbs Also See for CK30:

Table of Contents

Chapter 1 — Using the CK30 Handheld Computer

When you unpack the CK30, these bar code symbologies are

enabled:

• Code 39

• Code 128

• UPC/EAN

• PDF 417 (with Model C only?)

If you are using bar code labels that are encoded in a different

symbology, you need to enable the symbology on the computer.

Use the Configuration Utility to enable and disable symbologies

for your scanner. For help understanding how to use the

Configuration Utility, see "Configuring the CK30 With the

Configuration Utility" in Chapter 2.

The next sections describe how to scan a bar code label with the

integrated laser scanner, 1D linear imager and the 2D imager.

Scanning With the Integrated Laser Scanner and 1D Linear Imager

If the CK30 has a laser scanner or 1D linear imager, use the

following procedure to understand how to scan a bar code. The

linear imager can decode PDF417 bar codes as well as bar codes

with high-density, wide-density, and poor quality in any lighting

conditions.

To scan a bar code label with the laser scanner

1 Press Power to turn on the CK30.

2 Point the scanner window at the bar code label and hold the

computer at a slight angle a few inches from the label.

Note: If you have an advanced long-range scanner, you may

need to hold the computer further away from the label.

3 Press the Scan button on the keypad and direct the red beam

so that it falls across all bars in the bar code label.

Insert illustration

CK30 Handheld Computer User's Manual

Table of Contents