Scan Sensitivity Setting - Fm; Presetting Stations - Dab And Fm; Recalling A Preset Station- Dab And Fm - Sangean DDR-60BT Manual

Scan sensitivity setting - FM

Your radio includes a local/distant option for the auto-scan function. By setting the radio to the
'local' scan option, weaker signals from more distant transmitters can be ignored by the radio,
making stronger signals easier to find.
1. Press and release the Standby button to switch on your radio.
2. If needed, press and release the Mode button until the FM band is selected.
3. Press and hold the Menu button until the Advanced FM menu shows on the display.
4. Rotate the Tuning control until 'FM Scan Zone' shows on the display. Press and release the
Select button to enter the scan sensitivity adjustment mode. The current setting will be marked
with an asterisk.
5. Rotate the Tuning control to switch between 'Local' (Strong stations only) and 'Distant' (All
stations) options on the lower line of the display. The Distant option will allow the radio to find
weaker signals when scanning.
6. P ress and release the Select button to confirm your selection. The Local or Distant setting is
stored in the radio and remains in force until changed or until a System Reset.

Presetting stations - DAB and FM

You may store your preferred DAB and FM radio stations to the preset station memories. There
are 20 memory presets in your radio 10 for DAB and 10 for FM. Presets are remembered by your
radio in the event of a power failure.
The procedure for setting presets and using them to tune stations is the same for FM and DAB
modes, and is described below. Please note that 10 memory presets for each band can be
accessed via remote control.
1. Press the Standby button to switch on the radio.
2. Tune to the required station as previously described.
3. Press and hold down the required Preset button until the display shows, e.g. "Preset 1 stored."
The station will be stored under the chosen preset number. Repeat this procedure for the
remaining presets.
Note: Stations stored in preset memories may be overwritten by following the above procedure.

Recalling a preset station- DAB and FM

1. Press the Standby button to switch on the radio.
2. Press and release the required waveband by pressing the Mode button.
3. Momentarily press and release the required Preset button, your radio will tune to the station
in preset memory.
Note: The display will show 'Preset Empty' if no station has been stored to that preset.
FM
<FM Scan Zone
FM Scan Zone *
<Distant
FM Scan Zone
<Local
Preset 1
Stored
GB
>
>
>
10