Table of Contents
Advertisement
Introduction
Controller Card
Figure 12: Controller Card Faceplate
1
2
The controller card in the Cisco UBR-RFSW-ADV has two RS-232 COM ports—COM 0 and COM 1. COM
0 must be connected to the AUX port of the primary Performance Routing Engine (PRE) on the Cisco
uBR10012 router using an RJ-45 to RJ-45 rollover cable.
COM 1 may be connected to the AUX port of the secondary PRE, for redundancy purposes.
The table below describes the LEDs on the controller card.
OL-24104-01
Captive screws
LEDs
3
RJ-45 ports
4
Power LED
Cisco uBR Advanced RF Switch Hardware Installation Guide
Controller Card
13
Advertisement
Table of Contents
