Page 1
NFINITY UBWOOFERS EFERENCE Owner’s Manual SUB R10 SUB R12...
Page 2
SUBWOOFER REAR-PANEL CONTROLS AND CONNECTIONS SUB R10/R12 1) Crossover Control: This control determines the highest frequency at which the 6) On/Standby LED: When the Power switch is in the ‘On’ position, this LED indicates subwoofer reproduces sounds. The higher you set the Crossover control, the higher in whether the subwoofer is in the On or Standby state.
find the location where the bass performance is best. Place the subwoofer in that location. CONNECTING THE SUBWOOFER TO A RECEIVER OR PREAMP/PROCESSOR WITH A LOW-PASS FILTERED DEDICATED SUBWOOFER OUTPUT Receiver/Processor SUBWOOFER LFE OUT TO A RECEIVER OR PREAMP/PROCESSOR WITH PREAMP OUTPUTS Receiver/Processor PREAMP OUTPUT INFINITY REFERENCE SUBWOOFERS...