Installing Utilities - Cisco Aironet 350 Series Quick Start Manual

Installing Utilities

After you have installed the appropriate driver for your system, you can install the Aironet
Client Utilities (ACU), Link Status Meter (LSM), and Client Encryption Manager (CEM)
utilities. Installing utilities is optional unless using Wired Equivalent Privacy (WEP) in your
network. If WEP is enabled, all devices in the network must have the same WEP code, which
you set using the CEM utility. The ACU and LSM utilities provide troubleshooting and status
information, but are not required.
Refer to Using the Cisco Aironet 350 Series PC Card Client Adapters on the on the Client
Adapter CD for instructions on how to use each utility.
1
Insert the CD-ROM for your operating system into your computer CD-ROM drive.
2
Select Start > Run and enter the following path (where D is the letter for your CD-ROM
drive): D:\utils\setup.exe
3
Follow the setup instructions on the screen to complete the installation.
Note: After you have installed the appropriate driver and utilities, contact your IS department
if you have a problem connecting to the network.
6