Assembly; Operation - Ryobi P719 Operator's Manual

WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance. In Mexico, please call 01-800-843-1111.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
APPLICATIONS
You may use this product for the following purpose:
 Light-duty vacuuming of dry surfaces
 Household type
INSTALLING/REMOVING BATTERY PACK
See Figures 1 - 2, page 7.
 Place the battery pack in the stick vacuum. Align the raised
rib on the battery pack with groove in stick vacuum's battery
port.
 Make sure the latches on each side of the battery pack
snap into place and that the battery pack is secured in
the stick vacuum before beginning operation.
 Locate the latches on the side of the battery pack and
depress both sides to release the battery pack from the
stick vacuum.

ASSEMBLY

WARNING:
Do not attempt to modify this product or create acces-
sories or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious personal injury.

OPERATION

NOTE: It is not necessary to remove the battery pack from
the tool to recharge.
 With the battery installed, place the tool on the wall-
mounted charger by aligning the raised ribs on the tool
housing with the grooves on the charger.
 Slide the tool down until it is fully seated on the charger.
NOTE: The LED indicator will flash quickly to evaluate,
intermittently while charging, and will fade in and out when
fully charged.
STARTING/STOPPING THE VACUUM
See Figure 3, page 7.
 To start the vacuum: press the ON/OFF button once for
HIGH speed. Press the ON/OFF button again for LOW
speed.
 To stop the vacuum: press the ON/OFF button a third
time.
USING THE ROLLER BAR
See Figures 4 - 5, page 8
The roller bar can connect directly to the vacuum for clean-
ing upholstery and stairs or attach with the extension wand
for normal floor vacuuming.
NOTE: When not in use, always store the unit on the charger
base or lie flat to prevent falling over. Never stand alone in
the upright position.
To connect:
 Switch off unit and remove the battery pack.
 Align the pins on the roller bar with the receptacle in the
stick vacuum or extension wand.
 Press together until it clicks into place.
 Replace battery pack.
To remove:
 Switch off unit and remove the battery pack.
 Depress locking tab and pull to remove.
5 — English