Table of Contents
Advertisement
Permanent mount installation
When permanently installing the antenna on vehicles, some
important guidelines must be followed in order to ensure long
and trouble free operation.
Not following these guidelines will void the warranty of the
antenna. If in doubt, please consult SpaceCom at
spacecom@spacecom.dk
or call (+45) 98511576, Service
Department.
1. Always install the antenna so that it is in a horizontal
position, even if the surface on which it is installed e.g. roof
of a vehicle, is not horizontal.
The antenna has three drainage holes at the bottom.
2. Always install the antenna so that clearance between
bottom of antenna with drainage holes and mounting
surface is no less than 5 mm and preferably 10 mm, refer
to Fig.2.
In order to fulfill the above criteria 1 and 2, a set of bolts and
washers has to be defined for each individual installation; refer
to Fig.1.
The M5 stainless steel washers are always used and
positioned as shown in Fig.1. The rubber washers are always
used and positioned as shown in Fig.1.
The spacers are always used and positioned as shown in Fig.1.
20
3004129-0001 Revision E
Advertisement
Table of Contents
