Anynet+ (HDMI-CEC)
Anynet+ (HDMI-CEC)
Anynet+ is a function that enables you to control all connected Samsung devices that support
Anynet+ with your Samsung product remote. The Anynet+ system can be used only with
Samsung devices that have the Anynet+ feature. To be sure your Samsung device has this
feature, check if there is an Anynet+ logo on it.
•
Off
/
On
― You can only control
Anynet+
devices using the product remote control, not the buttons on
the product.
― The product remote control may not work under certain conditions. If this occurs, reselect
the
Anynet+
device.
―
Anynet+
works when the AV device supporting
―
Anynet+
supports up to 12 AV devices in total. Note that you can connect up to 3 devices of
the same type.
Anynet+
is in the standby or on status.
Troubleshooting for Anynet+
Problem
Possible Solution
Anynet+ does not work.
•
Check if the device is an Anynet+ device. The Anynet+
system supports Anynet+ devices only.
•
Check if the Anynet+ device power cord is properly
connected.
•
Check the Anynet+ device's Video/Audio/HDMI cable
connections.
•
Check whether
System
•
Check whether the remote control is Anynet+ compatible.
•
Anynet+ doesn't work in certain situations. (initial setup)
•
If you have removed and then reconnected the HDMI cable,
please make sure to search devices again or turn your
product off and on again.
•
Check if the Anynet+ function of the Anynet device is set on.
I want to start Anynet+.
•
Check if the Anynet+ device is properly connected to the
product and check if the
the
System
I want to exit Anynet+.
•
Press the SOURCE button on the product remote control
and select a non- Anynet+ device.
The message
•
You cannot use the remote control when you are configuring
"Disconnecting
Anynet+ or switching to a view mode.
Anynet+ device
..."
•
Use the remote control after the product has completed
appears on the screen.
Anynet+ configuration or has finished switching to Anynet+.
The Anynet+ device
•
You cannot use the play function when initial setup is in
does not play.
progress.
Anynet+ (HDMI-CEC)
is set to
On
menu.
Anynet+ (HDMI-CEC)
menu.
in the
is set to
On
in
78