DISASSEMBLY INSTRUCTIONS (CONT)
Electrical Parts
NOTE: Remove the front panel (refer front panel removal steps) before disassembling electrical parts.
Procedure
1) Cut the ribbon with a shear, then pull
out the coil temperature sensor (T2)
(see CJ_OP_INV_010).
2) Remove the two screws used for
the ground connection (see CJ_OP_
INV_010).
3) Remove the screws (1 for the
electronic cover and 1 for the terminal
cover). Next, remove the electronic box
cover and the terminal cover along
the direction indicated in image
(on the right side) to remove it.
4) Disconnect the fan motor connector
and the step motor (see CJ_OP_
INV_011).
Illustration
Ground Screws
Ribbon
CJ_OP_INV_010
CJ_OP_INV_011
39
T2 Sensor