Pyle PSW101CM Installation Manual

Tilt flat panel tv bracket multifunctional double deck wall mount

Hide thumbs Also See for PSW101CM:

Download this manual

Enlarged version

Step 3: Hanging display

Firstly lift the bracket mounted display over the wall mount. And then hook the

brackets over the top of the wall mount. Rotate the display let the bottom of the

brackets hook over the bottom of wall mount, as shown in Fig.3a. Then put safe

bolts into the bottom of the brackets and lock it, as shown in Fig.3b.

Warning:

Warning: Some TV require two people to lift, as we are not responsible for any

personal injury or product damage due to mishandling.

2,3

Fig 3a

Thank you for choosing our products

-8-

Fig 3b

Tilt Flat Panel TV Bracket

Multifunctional double deck wall mount

INSTALLATION GUIDE

Easy installing: Just hang up the display

Safety: locking by spinning bolt on the bottom

Max load capacity:60kg/132lbs

TV size range: 42 ~65

～

Adjustable angle: 5

Inside has balance adjust system

leveler system

IMPORTANT: If don't understand about right install ways, please

IMPORTANT:

consult to normal installing specialist.

Page 1 Step 3: Hanging display Step 3: Hanging display Firstly lift the bracket mounted display over the wall mount. And then hook the brackets over the top of the wall mount. Rotate the display let the bottom of the brackets hook over the bottom of wall mount, as shown in Fig.3a. Then put safe bolts into the bottom of the brackets and lock it, as shown in Fig.3b.
Page 2 Hardware List: Hardware List: Actual parts may appear slightly different than illustrated. Description Wall mount Left bracket Right bracket Safe bolt ×12 bolt ×16 bolt M5× bolt M6× bolt M8×16mm bolt Description M ×36mm bolt M6×36mm bolt M ×36mm bolt Square washer Long bolt Wall anchor...
Page 3 Step 2: Step 2: Attach mount to wall Attach mount to wall First, determine the height of stand The best height of stand is parallel to eyelevel of a person who sitting on a couch. Normally, the horizontal distance of eyelevel is about 4’ from ground level. The following two conditions are for determining the perfect height of stand: 1) the distance between wall and couch(Fig 2a).
Page 4 Following examples shows how to use bolts, spacers and square washers. 1.Some displays have vertical backs. No spacer is required. Install the bracket directly to the back of display by using bolts and square washers provided. As shown in Fig.1a. M4 Fig bit M6 Fig bit Fig 1a...