Install Remote Control Batteries; Set Clock - Philips HSB3280 User Manual

3
Connect the other end to the wall outlet.
4
Connect the power plug of the digital
wireless subwoofer to the wall outlet.
18 EN
Install remote control
batteries
Caution
•
Risk of explosion! Keep batteries away from heat,
sunshine or fi re. Never discard batteries in fi re.
•
Perchlorate Material - special handling may apply. See
www.dtsc.ca.gov/hazardouswaste/perchlorate.
For fi rst-time use:
1
Remove the protective tab to activate the
remote control battery.
To replace the remote control battery:
1
Open the battery compartment.
2
Insert one lithium CR2025 battery with
correct polarity (+/-) as indicated.
3
Close the battery compartment.
Note
•
Before pressing any function button on the remote
control, fi rst select the correct source with the remote
control instead of the main unit.
•
If you are not going to use the remote control for a
long time, remove the battery.

Set clock

1
In the standby mode, press and hold SET
TIME/PROG to enter the clock setting
mode.
»
The hour digits are displayed and begin
to blink.
»
If the hour digits are not displayed,
press and hold
seconds to switch to standby mode,
then repeat step 1.
2
Press + VOL - to set the hour.
»
The minute digits are displayed and
begin to blink.
3
Press + VOL - to set the minute.
for more than 2