Pyle view PLVWAN1 Installation Manual

Powered Diversity TV Antenna
P LV WA N 1
Installation Manual
Parts Supplied
1. TV Antenna(2) 1. TV Antenna(2)
2. Power Cord Holder(6) 2. Power Cord Holder(6)
3. Antenna Cable Holder(4) 3. Antenna Cable Holder(4)
4. Cigarette Light Plug(1) 4. Cigarette Light Plug(1)
5. Seal(2) 5. Seal(2)
Antenna
Loading coil
Antenna cable
Antenna plug
Booster amp section
Power cord
Note:
1. Use only on vehicles with 12-14.4 Volt battery
2. Avoid short circuits by disconnecting the negative(-)battery
cable before beginning installation.
3. Protect the wiring by wrapping adhesive tape around
exposed areas.
4. Antenna wires should not get in contact with moving
parts, areas of hot or sharp surfaces.
5. Avoid installing in areas that may get wet with rain.
Failure to do so may result in fire or electrical shock.
Proper Location
Mount the antenna on the inside rear window of the car.
For optimum reception, mount the antenna pointing
down.(See Fig 2)
Leave a minimum of 1 inch space between the antenna
wires and the edge of the window.
Location should not impair driver s view. Location should not impair driver s view.
Do not mount near or next to an existing antenna.
Be certain that there is enough cable to reach the unit.
Trial fit the antenna-do not remove protective paper from
booster or antenna sections.
(Fig 1)
(Fig 2)