Yamaha RS7000 Service Manual page 18

RS7000
9-5 PNSW Circuit Board:
Pull out the four (4) encoder knobs marked [B] and remove the
twelve (12) screws marked [150]. The Panel SW-Button
assembly can then be removed. (Fig.6, 7)
Pull out the thirty (30) buttons from the PNSW circuit board.
9-6 PNVR1 Circuit Board:
Pull out the four (4) knobs marked [C] and remove the three (3)
screws marked [300]. The PNVR1 circuit board can then be
removed. (Fig.6, 7)
Pull out the function button from the PNVR1 circuit board.
9-7 PNVR2 Circuit Board:
Pull out the twenty-one (21) knobs marked [D] and remove the
ten (10) screws marked [220]. The PNVR2 circuit board can
then be removed. (Fig.6, 7)
Pull out the eight (8) buttons from the PNVR2 circuit board.
9-8 PAD Circuit Board:
Remove the three (3) screws marked [260]. The PAD circuit
board can then be removed. (Fig.6)
9-9 LCD Assembly, Back Light Assembly:
Remove the six (6) screws marked [60]. The LCD assembly, the
back light assembly, the spacer assembly and the LCD angle
assembly can then be removed. (Fig.6, 8)
* When the LCD assembly is installed, be careful that a position
to install it doesn't deviate.
[220]
<Bottom View>
[220]
PNVR2
PAD
[260]
[60]: Bind Head Tapping Screw-B
3.0X6 MFZN2BL (EP600230)
[150]: Bind Head Tapping Screw-B
3.0X6 MFZN2BL (EP600230)
[220]: Bind Head Tapping Screw-B
3.0X6 MFZN2BL (EP600230)
[260]: Bind Head Tapping Screw-B
3.0X6 MFZN2BL (EP600230)
[300]: Bind Head Tapping Screw-B
3.0X6 MFZN2BL (EP600230)
18
[300]
[60]
PNSW
[150]
Fig.6
<Top View>
PNVR1
LCD Assembly
[B]
[60]
[150]
Back Light Assembly
[60]
LCD Angle Assembly
[60]: Bind Head Tapping Screw-B
3.0X6 MFZN2BL (EP600230)
[C] [D]
Fig.7
Spacer Assembly
LCD Assembly
[60]
[60]
Fig.8
[D]
[D]
[D]