Connection Diagram; Replacing The Remote Control Battery - Pyle view PLVHR72 Instruction Manual

Connection Diagram

Replacing the Remote Control Batter y
1)Always use new battery when replace the old set.
2)Do not attempt to charge, short-circuit, disassemble,
heat or burn used batteries, battery may be explode
if mistreated.
3)Battery replacement is necessary when remote
control acts sporadically or stops operating.
4)Do not drop, apply shock or step on the remote control.
5)Do not spill water on the remote control.
6)Do not place objects between the remote control and remote sensor.
7)Do not use remote control for the other equipments at the same time.
8)Do not leave the remote near any heat sources, or in a place subject to direct sunlight
(especially on the dashboard).
9) Keep the lithium battery out of the reach of children. Should the battery be swallowed, immediately
consult a doctor.
10)If the MONITOR does not operate even when you operate the remote control from a close range,
it is time to replace the battery (use CR-2025 lithium battery), refer ring to the label on the back of
the basic control.
11)Do not hold the battery with metallic tweezers, otherwise a short-circuit may occur.
White RCA: Mono Audio Input
Yellow RCA:Video Input
Red wire :DC +12Volts Power Input (
Black wire: Ground (negative earth)
1
Fuse replacement
Never use fuse with an amperage rating exceeding the one supplied
with the unit as this could damage the unit.
When replacing the fuse, be sure to use one that matches the
amperage described on the original fuse. If the fuse blows, check the
power connection and replace the fuse. If the fuse blows again after
replacement, there may be an internal malfunction. In such a case,
consult your nearest your's dealer.
car battery )
PULL OUT
PUSH IN
6
2
Fuse
(2A)