All Detectors Except Oxygen; Oxygen Detectors Only - Honeywell Sensepoint Technical Manual

There is a procedure for all sensors except oxygen, and one for oxygen only. The procedure
activates the sensor before putting the detector into service.

All Detectors EXCEPT Oxygen

a. Remove the sensor cap.
Unscrew the cap in a counter-clockwise direction. Refer to the following diagram.
b. Remove the protective disc from inside the sensor cap.
Discard the disc.
All Detectors
EXCEPT
Oxygen
b
a
c. Refit the sensor cap.
Screw the cap in a clockwise direction. If required fit an accessory. Refer to the instructions
supplied with the item except for fitting outer filters, see page 19.

Oxygen Detectors ONLY

a. Remove the sensor cap.
Unscrew the cap in a counter-clockwise direction. Refer to the following diagram.
b. Remove the protective disc from inside the sensor cap.
Discard the disc.
c. Remove the cell's protective plug.
The plug is stuck to the face of the sensor's cell using a light adhesive. Peel the plug off and
discard it.
2106M0525 Iss 2 Nov 05
Protective Disc
Counter-clockwise
Sensor Body
Sensor Cap
c
Clockwise
Installation
17