IMPORTANT NOTICE This Compact Disc Changer/Player has been tested and found to comply with the limits for a class B digital device in accordance with the specifications in Subpart J of part 15 of FCC Rules. This equipment generates and uses radio frequency energy, and it must be installed and used properly in accordance with the manufacturer's instructions.
Indication on controller display is erratic. REMOVE THE TRANSPORT SCREWS Four screw that lock the CD player's mechanism during transport are located on the bottom of the unit. Remove these screws and keep with your literature package for future use should the unit need to be transported for service/maintenance.
LOCATION OF CONTROLS 1. Compact Disc Magazine Slot 2. Reset Button 3. Eject Button (Press this button to eject the Magazine) 4. Slide Door WIRING CONNECTIONS CD CHANGER CAR RADIO...
Page 5
HOW TO USE THE COMPACT DISC MAGAZINE Inserting Discs Inserting Discs into the supplied magazine. Up to 6 Discs may be inserted into the magazine. The Disc are numbered from 1 (bottom tray) to 6 (top tray). Note: Do not touch the recorded side of a Disc while inserting or removing it. Removing Discs 1.
INSTALLATION • Use the supplied parts and mount the unit securely. The use of parts other than these supplied (specified) may loosen or damage internal components. • If installation presents any difficulties, consult your dealer for advice. • Before drilling a hole into the wall or floor the vehicle trunk, check that nothing is behind the panel.
Page 7
ACCESSORIES a) Bracket d) Wing nut (06) e) Self tape screw (5x15) Important Angle set and locking screws • Be sure to adjust the mounting angle set screw (F) using the mounting angle adjust key to appropriate angle: Of for horizontal. 45° angle. or 90° for vertical mounting. •...
INSTALLATION DIAGRAMS HORIZONTAL / VERTICAL INSTALLATION PROCEDURES 1. Attach the brackets (a) to each side of the unit. Using the hex bolts with washers (c). 2. Determine the mounting location and drill 4 mounting holes approximately 3.5mm in diameter . 3.
VERTICAL INSTALLATION Attach the brackets (a) to each side of the unit using hex bolts with washers (c). Attach the floor base plate (b) to the brackets a) using the wing nuts (d) Press the unit to the floor, and remove the wing nuts (d), and lift off the changer FOR AN ANGLED INSTALLATION, TURN TO THE 45°...
SPECIFICATIONS General System Usable Discs Operation voltage Power consumption Operating electric current Max. peak electric current Dimensions Operational temperature range Temperature range of storage Test condition Audio Frequency range Dynamic range Distortion (THO N) S/N ratio Channel separation Audio output level Wow &...
OPERATION Liquid Crystal Display (LCD) - (1) LCD display will only be active when the changer power is on. This display indicates all operation key's, including DISC number. Track number, and DISC icon. Random Play Button - (2) (Track or DISC Random) This is used for random selection Disc play, and sequence.
- When the system is turned off in the car power always goes back to the radio, not back to the CD player. - When power is restored to the CD System. It does not start where it was last playing.