Installing The Battery - Toro 74096 Setup Instructions

7

Installing the Battery

Parts needed for this procedure:
2 J-bolt
2 Wing nut
1 Hold-down clamp
Procedure
Important:
This procedure only applies to
machines that do not come with a battery
installed.
Purchase a 12 V battery and install it into the machine.
The engine requires a minimum of 540 A (cold
cranking).
Use the hardware included to install the new battery.
Refer to Installing the Battery in the Operator's
Manual.
8
Raising the Rollover
Protection System (ROPS)
No Parts Required
Procedure
1. Pull the knob and rotate 90° to the unlatched
position (Figure
2. Raise the roll bar to the operate position, and
rotate the knobs so that they move partially into
the grooves (Figure
3. Raise the roll bar to the full upright position while
pushing on the upper roll bar and the pins snap
into position when the holes align with the pins
(Figure 4).
Important:
Always use the seat belt with the
roll bar in the raised position.
1. Upper part of the roll bar
2. Knob in the latched
position
3. Pull the knob to unlatch.
4. Push on the roll bar and ensure that both pins
are engaged (Figure
4
4).
4).
Figure 4
4. Rotate the knob out 90°
to hold it in the unlatched
position.
5. Knob in the unlatched
position
5).
g243267