Ransomes ZT220D W/61 Safety & Operation Manual page 23

MAINTENANCE
ZT 220D
Series
LUBRICATION
Every 50 hours of operation, lubricate the following points (1-6) with grease:
1. Deck lift rockshaft (1 point)
2. Deck idler pivot bearings (2 points)
3. Deck lift pivots (6 points)
4. Hydro belt tensioner (1 point under engine deck)(service through hole in discharge deflector)
5. Brake lever pivot (1 point)
6. Push arms (2 points located at rear of cutterdeck under each fuel tank)
7. Caster wheel pivots (2 points)
(Lubricate every 500 hours or once a year)
NOTE ON BLADE SPINDLES - The blade spindles on these machines use a superior sealed bearing
that does not require relubrication.
GB-21