ProForm PFTL78807.2 User Manual page 7

1. Make sure that the power cord is unplugged.
With the help of a second person, carefully tip
the treadmill onto its left side. Partially fold the
Frame (56) so that the treadmill is more stable;
do not fully fold the Frame yet.
Remove and discard the two indicated bolts (A)
and the shipping bracket (B).
Cut the ties securing the Upright Wire (38) to the
Base (83). Locate the plastic tie in the indicated
hole in the Base, and use the plastic tie to pull
the Upright Wire out of the hole.
Attach a Base Pad (81) to the Base (83) in the
location shown with a Base Pad Spacer (13) and
a #8 x 1" Tek Screw (2). Then, attach another
Base Pad (81) with only a #8 x 1" Tek Screw (2).
2. Remove the 3/8" Nut (8), the 3/8" x 2" Shoulder
Bolt (113), and the shipping bracket (C) from the
Base (83). Attach a Wheel (84) with the Bolt and
the Nut that you just removed. Do not over-
tighten the Nut; the Wheel must turn freely.
Discard the shipping bracket.
3. With the help of a second person, hold the Right
Upright (78) near the Base (83). Identify the
Right Upright and the Right Upright Spacer (79),
which are marked with stickers. Insert the
Upright Wire (38) through the Right Upright
Spacer as shown. Set the Right Upright Spacer
on the Base. Be careful not to pinch the
Upright Wire.
See the inset drawing. Tie the long tie in the
Right Upright (78) securely around the end of
the Upright Wire (38). Then, pull the other end
of the long tie until the Upright Wire is routed
completely through the Right Upright.
1
Hole
38
Plastic
Tie
13
81
56
2
83
113
84
C
8
3
38
78
38
Long
Tie
7
B
A
83
2
78
Long Tie
38
79
81
2
83