Crown Molding Stopper - Makita DLS110 Instruction Manual

Table (A)
– Molding Bevel angle
position
52/38°
in the
type
figure
For (a) Right
inside 33.9°
corner
(b)
For (c)
outside
(d)
corner
Table (B)
– Molding
position in
the figure
For inside (a)
corner
(b)
For outside (c)
corner
(d)
Example:
In the case of cutting 52/38° type crown molding for
position (a) in the above figure:
• Tilt and secure bevel angle setting to 33.9° RIGHT.
• Adjust and secure miter angle setting to 31.6° RIGHT.
•
Lay crown molding with its broad back (hidden) sur-
face down on the turn base with its WALL CONTACT
EDGE against the guide fence on the saw.
• The finished piece to be used will always be on
the RIGHT side of the blade after the cut has been
made.

Crown molding stopper

Optional accessory
Crown molding stoppers allow easier cuts of crown
molding without tilting the saw blade. Install them on the
turn base as shown in the figures.
At right 45° miter angle
1
► 1 . Crown molding stopper L 2. Crown molding stop-
per R 3. Turn base 4. Guide fence
Miter angle
45° type 52/38° 45° type
type
Right Right Right
30° 31.6° 35.3°
Left Left
31.6° 35.3°
Right Right
31.6° 35.3°
Molding Finished
edge against piece
guide fence
Wall contact Finished
edge should piece will be
be against on the Right
guide fence. side of blade.
Ceiling
contact edge
Finished
should be
piece will be
against guide
on the Left
fence.
side of blade.
Wall contact
edge should
be against
guide fence.
2
3
4
At left 45° miter angle
1
2
3
► 1 . Crown molding stopper L 2. Crown molding stop-
per R 3. Turn base 4. Guide fence
Position crown molding with its WALL CONTACT EDGE
against the guide fence and its CEILING CONTACT
EDGE against the crown molding stoppers as shown in
the figure. Adjust the crown molding stoppers according
to the size of the crown molding. Tighten the screws to
secure the crown molding stoppers. Refer to the table
(C) for the miter angle.
1
► 1 . Guide fence 2. Crown molding stopper
1. Inside corner 2. Outside corner
26 ENGLISH
(a) (b) (c) (d)
1 2
4
2