Honeywell Tema-Voyager Compact Installation Manual page 38

7
8
9
10
11
12
13
This support is used for installing the reader on horizontal surfaces.
Typical installation is for the use on the turnstile.
32 https://extranet.honeywell.com
Route the interface and power cables from the wall to the reader
through one of the three holes in the base of the swivel.
Route the cables through the swivel ball, being careful to ensure that
the cables are on the same side of the connectors on the reader. Do not
cross the cable inside the ball. Leave about 5-6 cm of excess cable.
Attach the swivel to the wall using the three screw holes, paying
attention to the right position as shown in
UP inside the base.)
Fix the swivel ball on the support by giving the desired slope. The
swivel ball has a key to prevent you from installing the ball upside
down.
Connect the cable to the 3.5mm Pitch Plugs and other connectors. Be
sure to connect the wires by paying attention to the right position
shown in Figure 6 (the screws must be on the side of the Ethernet
connector). Be sure that there are no short circuits between the wires.
Use the bayonet fitting shown in
Use the 2x Torx screws to lock the reader onto the support.
Mounting the device on the turnstile mount
Figure 20 Turnstile support (front and back views)
Figure 15. (Check the arrow
Figure 7 to close the reader.