Page 1
NEC Display Solutions of America, Inc. QIG-TMX4P-554UNS X554UN-TMX4P, X554UNS-TMX4P Rev 1.1 Parts List o (4) X554UN or X554UNS Displays o (4) Onsite Service Warranties (ONSITEMN-3Y-16 or ONSITEMN-3Y-17) o (4) Peerless Pullout Wall Mounts (DS-VW765-L40) o (1) 25ft Cat5e Patch Cable o (4) 3m DisplayPort 1.2 Cables...
Page 2
Industries, Inc. inside the box of the DS-VW765-L40. Connect the NEC display using the provided DisplayPort cables. Please note that in the picture below, the IN connection is on the left and circled in red while the OUT connection is on the right and circled in blue.
Page 3
NEC Display Solutions of America, Inc. QIG-TMX4P-554UNS X554UN-TMX4P, X554UNS-TMX4P Rev 1.1 Screw the IR Receiver (KT-RC2) directly to the outside of the video wall and plug it directly into the IR In terminal of Display 1 as shown below. Power up all of the displays and make sure that the LAN power is on for each display. This can be found in the External Control menu.
Page 4
NEC Display Solutions of America, Inc. QIG-TMX4P-554UNS X554UN-TMX4P, X554UNS-TMX4P Rev 1.1 If the control setup is as pictured below, each display does not need a unique IP address assigned to still control each individual monitor. Note that a unique IP address is not necessary to communicate to all displays if display 1 is not connected to a network.
Page 5
NEC Display Solutions of America, Inc. QIG-TMX4P-554UNS X554UN-TMX4P, X554UNS-TMX4P Rev 1.1 If display 1 is connected to a network or LAN is going into display 1, like the picture below, each display will need a unique IP address to ensure that communication can successfully go through the daisy chain from screen to screen.
Page 6
NOT daisy chain to the consecutive displays. If inputting through the DisplayPort terminal then the limitation of distributing video to consecutively daisy chained displays is a total of 3 units. NEC Display Solutions recommends that an HDCP compliant distribution amplifier is utilized for all HDCP applications.